The Core i7-12700K is set at a 4.7GHz clock at 1.3v on all performance cores to ensure consistent power consumption across test scenarios. Thermal Results for the Hyte Y60įor the thermal tests, all case and CPU fan speeds are set to 100%. I measured the rear exhaust fan using our laser tachometer and it read 1,444 RPM, which is fairly close to the rated 1,500 RPM. That can be attributed to the location of the bottom fans, since they’re shoved in the case’s basement, and likely also the glass panels dampening internal noise. After screwing in the power supply and routing the cables, I tied them down with minimal effort, and wound up with the cleanest cable management job I’ve ever accomplished. I really like dual-chamber layouts because they make cable management much easier. The Y60 features a dual-chamber design– similar to what we see in other chassis with this footprint, with the PSU and storage mounted behind the motherboard area. This case fits cards up to 14.76 inches (375mm), which means your Asus ROG Strix RTX 3090 or PowerColor Red Devil RX 6900XT should fit here without issue. Hyte was more generous on the GPU side in terms of clearance. But, with a case like this, wouldn’t you rather show off your RGB-adorned AIO? As we’ll soon see in testing, going with an AIO might be a better choice for temperatures too. But while Hyte claims this case can fit SSR-CEB/EEB (E-ATX) motherboards, our standard-ATX Gigabyte Aorus Z690 Ultra was already a fairly tight fit.ĬPU cooler support is limited to 6.3 inches (160mm), which means owners of Noctua’s NH-D15s or Deepcool’s Assassin III will not be able to those chonky coolers. (Image credit: Tom's Hardware) Internal Layout And since you’re paying for the riser cable, it would be odd not to use it, especially in a case that’s all about showing off your components. Of course, your GPU can still be installed horizontally, but then you’re left with an awkward gap in the floor of the case. The riser cable itself works like a charm I had no issues installing our triple-fan Gigabyte RTX 3070 Ti Gaming OC, because this chassis supports GPUs up to 14.76 inches (375mm). But if you’re lazy like me, you’ll have to deal with it. This issue can be curbed by unscrewing the riser cable before system installation. The riser cable comes pre-installed, which made installing our motherboard frustrating, as the cable kept hitting the motherboard. This cable features a plastic piece at the top of it that mimics the top of the Y60 and is perfectly measured so there’s no excess cable length. The included riser cable is different than most others on that market that are basically just ribbon cables. We’ll figure out how that plays out shortly in the thermal testing section. Because often vertically mounting your GPU can have a negative effect on thermals. Hyte made a bold move by including a PCIe 4.0 riser cable and encouraging vertical GPU mounting.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |